Details:The RS90 is a 90mm
brushless fpv quad designed to be the ultimate indoor/proximity flyer.
Full propeller protection and a tiny form factor (4” x 6” flying size)
turn any location into an fpv playground without having to worry about
leaving prop marks everywhere. Despite a slightly heavier flying weight
compared to the typical quadcopter in this size class, brushless power
produces around 60g(@8.0V) thrust for a total thrust to weight ratio of
3.5!
-full prop guards mean you’ll almost never break props, saving money and time from balancing/drilling new props
-pusher props with essentially zero obstruction downstream for higher
efficiency and a much smaller chance of props flying off as they lose
grip on the motor shaft
-narrow
as possible motor to motor width (dimension orthogonal to the quads
forward direction of travel) to fly through the tightest gaps
-motors are completely surrounded by the frame, making it impossible for them to take a direct hit
-plastic (currently nylon) is soft and flexible making it less likely to damage surroundings, which is more important indoors
-no
electronics permanently attached to outer frame so rebuilds won’t
require any soldering, just a screwdriver and about 5 minutes
-frame rear weight bias to balance out the relatively large camera platform in front and potential hd camera
-motors mounts pushed outside of the frame to allow the use of lower
profile 12mm standoffs (originally used 18mm which requires a f/f and
m/f standoff) while still maintaining decent ground clearance
-integrated battery mount which provides support in the horizontal plane, preventing battery vibrations in flight
-slightly undersized motor screw holes for a sort of integrated nyloc. I
found that screws would vibrate loose with correctly sized holes.
Need a Custom RS90 Case (Links below):



Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"