PFG Sport Micro Polycarbonate Frame
Take this extremely durable night flyer out for some fun.
Description:
There are many sport quad frames on the market, but none like this.
Based off a popular design style that has proven to be a durable and fun
drone to fly. We cut the frame from polycarbonate for two reasons, its
high durability and for installing LED’s for night flight. The single
piece main frame is cut from 3/16” polycarbonate and top plate from
1/16” to save weight. There is also an FPV camera kit that allows the
installation of a camera should you want to fly FPV.
With the expanding selection of mini quad electronics and easier to tune
open source boards coming to market there is a demand for frames that
will utilize all of the new products that have come to market. The
central frame has mounting for the common 30.5x30.5mm power distribution
and flight control spacing. Both the power distribution and flight
controller can fit into the center of the frame under the top plate that
allows you a little more surface are to secure any additional
electronics and protect your gear.
With the installation of an LED kit (sold separately) you will be able
to install four 5mm LED’s, one into each corner of the frame to
illumination each arm. On our in house model, we stared with the Mini
Power Distribution Board with Camera and VTX filters to power the four
Rc-Tiger Phoenix Flight Gear Edition MT1306 1900kv motors turning the
best in propellers, the T-Motor Carbon Prop 6x2. Feeding these motors we
went with an obvious choice, the T-Motor S6A Opto ESC’s given there
signals from a the Dragon Circuits Sparky flight controller. Motor
mounting is on the standard mini motor 12-14mm slots.
Don’t buy a new mini quad just to take it all apart and rebuild it! With
the new Dragon Circuits flight controller combined with the TAO Labs
flight control firmware and programming assistant building a great mini
quad has never been easier. The difficult to understand code based
programming and complicated and confusing PID settings are eliminated so
you need not worry about getting into the air and flying once your quad
is built. Just program your flight board, run the auto-tuning program
and spend the rest of your night flying.
These mini quad builds should take the novice only a few hours to
complete and require basic multirotor and commuter knowledge to program
your flight controller. Depending on your choice in build components and
flight style, flight time should be 5-7 min. we would recommend a
900-1300mah 3s battery.
Included:
PFG Sport Polycarbonate Frame
PFG Sport Polycarbonate Frame Top Plate
4 - 40mm nylon standoffs
4 - 30mm FF nylon standoffs
4 - 10mm FF nylon standoffs
4 - M3x3 spacers
16 - M2x8 screws
8 - M3x8 screws
8 - M3x6 screws
4 - M3x10 screws
Fish line
Adhesive Velcro
Velcro strap
Required tools:
2mm allen wrench
1.3mm allen wrench
Basic build supplies
Required to finish build:
Mini motors
Propellers
ESC’s
Power distribution
Flight Control
Radio
Battery
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
