Light up your new RotorX Atom frame with this Polycarbonate Front Bumper LED Frame Guard.
Great for night flying. Also
protects the front frame edge as it extends 1mm past the edge of the
front of the frame to keep the edge from getting damaged. Check out our Polycarbonate Frame Guard LED Set for full frontal protection and better visibility.
Installation is easy. Mount at the bottom of the frame using the screws included with your Atom frame kit. The screws go through the poly bumper and then into the frame and screw into the front standoffs Solder to your PDB or any 7.4v-15v power source.
You can also add a plug and power off your battery balance tap. Tuck the LED into the LED opening and use clear tape and/or the included fishing line to hold LED in place. You can also put a white or Silver backing between the polycarbonate and the frame arm for better light reflection.
LED Additional Information:
| Size | 3mm Pre-Wired Round Top |
|---|
| Color | Pure Green
|
|---|
| Luminosity/Brightness | 18,000-20,000 mcd |
|---|
| Forward Voltage | 7.4v-15v (volts) (15v Not Recommended Continuous) |
|---|
| Wire Length | Approximately 15cm (6 inches) |
|---|
| Resistor Built In | Yes |
|---|
| Additional Resistors Required | No |
|---|
| Shrink Wrapped Connections | Yes |
|---|
| Current | 20mA |
|---|
| Wavelength | 515-525nm |
|---|
| Viewing Angle | 20-30 Degrees |
|---|
| Mount Style | Custom |
|---|
| Lens Color | Clear |
|---|
| LED Brightness Class | Super/Ultra/Extreme |
|---|
| Operating Voltage | 10v-15v (volts) (15v Not Recommended Continuous)
|
|---|
We check all LED's before shipping to verify they work.
I am sorry but we cannot offer a warranty on LED's.
(1) Polycarbonate Front Bumper LED Frame Guard
(1) Phoenix Flight Gear 3mm Green LED
Fishing Line
