Light up your new RotorX Atom or Raiju frame with this Polycarbonate LED set.
Great for night flying. Also
protects the frame arm edges as this kit extends 1mm past the edge of
the arms to keep the edge of the arms from getting damaged. Check out our LED front bumper set for full frontal protection and better visibility. Installation is easy. Mount at the bottom of the frame arm using the included motor screws. Solder to your PDB or any 7.4v-15v power source. You can also add a plug and power off your battery balance tap. Tuck the LED into the LED opening and use clear tape and/or the included fishing line to hold LED in place. You can also put a white or Silver backing between the polycarbonate and the frame arm for better light refection.
Our
pre-wired LEDs are nothing but quality. The 12v 5mm pure red/green led puts
out a nice color that is sure the illuminate your product or project.
Our 5mm pre-wired leds have built in resistors so that they will work
with the voltage that they are rated for. There is no need for you to
add any additional resistors. The only thing you need to do is add power
/ ground and they will illuminate. It doesn't get much easier than
that.
The 5mm pre-wired leds come with a built in resistor,
all connections are heat shrinked in order to protect them and there is
sufficient wire lead on all of them.
LED will run on 7.4v-15v.
We
recommend that you don't continuously run them at 15 volts, but they
will take spikes as high as that without any issues at all.
LED Additional Information:
Size | 3mm Pre-Wired Round Top |
---|
Color | Pure Green / Pure Red
|
---|
Luminosity/Brightness | 18,000-20,000 mcd |
---|
Forward Voltage | 7.4v-15v (volts) (15v Not Recommended Continuous) |
---|
Wire Length | Approximately 15cm (6 inches) |
---|
Resistor Built In | Yes |
---|
Additional Resistors Required | No |
---|
Shrink Wrapped Connections | Yes |
---|
Current | 20mA |
---|
Wavelength | 515-525nm |
---|
Viewing Angle | 20-30 Degrees |
---|
Mount Style | Custom |
---|
Lens Color | Clear |
---|
LED Brightness Class | Super/Ultra/Extreme |
---|
Operating Voltage | 10v-15v (volts) (15v Not Recommended Continuous)
|
---|
We check all LED's before shipping to verify they work.
I am sorry but we cannot offer a warranty on LED's.
Included:(4) Phoenix Flight Gear Polycarbonate LED Pods