Phoenix Flight Gear PolyLights Polycarbonate
ZMR250/Blackout Motor LED Frame Guard Set
**Shown with optional front/rear LED Bumper Frame Guard set**
Click HERE to purchase
**Quad and electronics sold separately**




Light up your new ZMR250/Blackout Or any frame that uses 1800/2200 series motors with this Polycarbonate LED Motor Frame Guard Set.
Great for night flying. Also protects the arm frame edge as it extends 2mm past the edge of the arms to keep the arm edges from getting damaged. Check out our Polycarbonate Front/Rear Bumper Guard LED Set for full protection and better visibility.
Installation is easy. Mount at the bottom of the frame arms using the motor screws included with this kit. The screws go through the poly bumper and then into the frame and screw into the motors.
We include 2 Red and 2 Green LED so light up the LED's before installation and decide what color you want for front and back. Solder to your PDB or any 7.4v-15v power source.
You can also add a plug and power off your battery balance tap. Tuck the LED into the LED opening and use clear tape and/or the included fishing line to hold LED in place. You can also put a white or Silver backing between the polycarbonate and the frame arm for better light reflection.
Our
pre-wired LEDs are nothing but quality. The 12v 5mm pure green/red led puts
out a nice color that is sure the illuminate your product or project.
Our 5mm pre-wired leds have built in resistors so that they will work
with the voltage that they are rated for. There is no need for you to
add any additional resistors. The only thing you need to do is add power
/ ground and they will illuminate. It doesn't get much easier than
that.
The 5mm pre-wired leds come with a built in resistor,
all connections are heat shrinked in order to protect them and there is
sufficient wire lead on all of them. LED will run on 7.4v-15v.
We
recommend that you don't continuously run them at 15 volts, but they
will take spikes as high as that without any issues at all.
LED Additional Information:Size 5mm Pre-Wired Round Top
Color Pure Green/Pure Red
Luminosity/Brightness 18,000-20,000 mcd
Forward Voltage 7.4v-15v (volts) (15v Not Recommended Continuous)
Wire Length Approximately 15cm (6 inches)
Resistor Built In Yes
Additional Resistors Required No
Shrink Wrapped Connections Yes
Current 20mA
Wavelength 515-525nm
Viewing Angle 20-30 Degrees
Mount Style Custom
Lens Color Clear
LED Brightness Class Super/Ultra/Extreme
Operating Voltage 10v-15v (volts) (15v Not Recommended Continuous)
Included: (4) Phoenix Flight Gear Polycarbonate Motor LED Guards
(2) Phoenix Flight Gear 5mm Red LED's
(2) Phoenix Flight Gear 5mm Green LED's
(16) M3 x 10mm Button Head Screws
(16) M2 x 10mm Button Head Screws (16) M2 Thin Washers
Fishing Line
Weight:4- LED Motor Guards Total weight 15g
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"