Phoenix Flight Gear PolyLights Polycarbonate ZMR250/Blackout
Front/Rear LED Bumper Frame Guards
**Shown with optional Motor LED Frame Guard set**
Click HERE to purchase
![]()
*Shown with optional Motor LED Frame Guard set**
Click HERE to purchase
Light up your new ZMR250/Blackout Or any frame with 1.25" front standoff hole spacing with this Polycarbonate Front/Rear Bumper LED Frame Guard.Great for night flying. Also protects the front/rear frame edge as it extends 2mm past the edge of the front/rear of the frame to keep the frame edge from getting damaged. Check out our Polycarbonate Motor Arm Guard LED Set for full protection and better visibility.
Installation is easy. Mount at the bottom of the frame using the 2 screws included with this kit. The screws go through the poly bumper and then into the frame and screw into the standoffs.
We include 1 Red and 1 Green LED so light up the LED's before installation and decide what color you want for front and back. Solder to your PDB or any 7.4v-15v power source.
You can also add a plug and power off your battery balance tap. Tuck the LED into the LED opening and use clear tape and/or the included fishing line to hold LED in place. You can also put a white or Silver backing between the polycarbonate and the frame arm for better light reflection.
Our
pre-wired LEDs are nothing but quality. The 12v 5mm pure green/red led puts
out a nice color that is sure the illuminate your product or project.
Our 5mm pre-wired leds have built in resistors so that they will work
with the voltage that they are rated for. There is no need for you to
add any additional resistors. The only thing you need to do is add power
/ ground and they will illuminate. It doesn't get much easier than
that.
The 5mm pre-wired leds come with a built in resistor,
all connections are heat shrinked in order to protect them and there is
sufficient wire lead on all of them. LED will run on 7.4v-15v.
We
recommend that you don't continuously run them at 15 volts, but they
will take spikes as high as that without any issues at all.
LED Additional Information:Size 5mm Pre-Wired Round Top
Color Pure Green/Pure Red
Luminosity/Brightness 18,000-20,000 mcd
Forward Voltage 7.4v-15v (volts) (15v Not Recommended Continuous)
Wire Length Approximately 15cm (6 inches)
Resistor Built In Yes
Additional Resistors Required No
Shrink Wrapped Connections Yes
Current 20mA
Wavelength 515-525nm
Viewing Angle 20-30 Degrees
Mount Style Custom
Lens Color Clear
LED Brightness Class Super/Ultra/Extreme
Operating Voltage 10v-15v (volts) (15v Not Recommended Continuous)
Included:(2) Polycarbonate Front/Rear Bumper LED Frame Guards
(1) Phoenix Flight Gear 5mm Green LED
(1) Phoenix Flight Gear 5mm Red LED
(4) M3 x 14mm Button Head Screws
Fishing Line
Weight: (2) Polycarbonate Bumper Guards-7.5g
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
