Phoenix Flight Gear PolyLights Motor LED Polycarbonate Light Disc Set For 250mm Size frames
Light up your new 250 size frame with this Polycarbonate LED set.
Perfect for Phoenix Flight Gear Dragonfly frames
**Photo below shows exactly what is included**
![]()
Great for night
flying. Also protects the frame arm edges. Check out our LED front/rear
bumper set for full front/rear protection and better visibility.
Installation is easy. Mount at the bottom of the frame arm using the
included motor screws. Solder to your PDB or any 7.4v-15v power source.
You can also add a plug and power off your battery balance tap. Tuck the
LED into the LED opening and use clear tape and/or the included fishing
line to hold LED in place. You can also put a white or Silver backing
between the polycarbonate and the frame arm for better light refection.
Motor hole spacing for 2200 series motors and more.
Our
pre-wired LEDs are nothing but quality. The 12v 5mm pure green/red led puts
out a nice color that is sure the illuminate your product or project.
Our 5mm pre-wired leds have built in resistors so that they will work
with the voltage that they are rated for. There is no need for you to
add any additional resistors. The only thing you need to do is add power
/ ground and they will illuminate. It doesn't get much easier than
that.
The 5mm pre-wired leds come with a built in resistor,
all connections are heat shrinked in order to protect them and there is
sufficient wire lead on all of them. LED will run on 7.4v-15v.
We
recommend that you don't continuously run them at 15 volts, but they
will take spikes as high as that without any issues at all.
Additional Information
| Size | 5mm Pre-Wired Round Top |
|---|
| Color | Pure Red/Pure Green
|
|---|
| Luminosity/Brightness | 18,000-20,000 mcd |
|---|
| Forward Voltage | 7.4v-15v (volts) (15v Not Recommended Continuous) |
|---|
| Wire Length | Approximately 15cm (6 inches) |
|---|
| Resistor Built In | Yes |
|---|
| Additional Resistors Required | No |
|---|
| Shrink Wrapped Connections | Yes |
|---|
| Current | 20mA |
|---|
| Wavelength | 515-525nm |
|---|
| Viewing Angle | 20-30 Degrees |
|---|
| Mount Style | Custom |
|---|
| Lens Color | Clear |
|---|
| LED Brightness Class | Super/Ultra/Extreme |
|---|
| Operating Voltage | 10v-15v (volts) (15v Not Recommended Continuous) |
|---|
Included:
- (4) Phoenix Flight Gear Polycarbonate LED Discs
- (2) Phoenix Flight Gear 5mm Red LED's
- (2) Phoenix Flight Gear 5mm Green LED's
- (16) M3 x 10mm Button Head Screws
- (16) M2 x 10mm Button Head Screws
- (16) M2 Thin Washers
- Fishing Line
Weight:
4- LED Discs Total weight 8.5g
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
