Phoenix Flight Gear 110mm Carbon Fiber Micro-H FPV Racing Frame

**Photos below show a built MICRO accessories and electronics OPTIONAL**
Shown with Optional AlienWii Flight Control Accessory Protector Plate




The
micro frame market has taken off with a revolution in flight
controllers and a variety of coreless motors. This super light racing
frame has a second top plate that secures your micro motors the top and
bottom the motors strengthening the frame. Securing the motors with two
points also makes this the most rigid frame that we have to offer to
date. Build able with either 7 or 8mm motors you will be able to upgrade
and reconfigure as your skills improve. With minimal nylon hardware and
foam motor mounting we keep this frame light and easy to assemble.
For
the racer in you, the top plate can be shifted forward with 7mm motors
installed for face paced racing. Another reason we chose a two plate
frame was to strengthen the frame to make it more rigid. To protect
your flight controller we have also made two optional flight controller
yards, one for the AlienWii and one for the blade NanoQX and Hubsan X4.
If you are flying FPV we also have mounting place for an antenna
protector post for the Spectrum VA1100. There is also a ledge for
mounting the VA1100 and micro pico cameras on the front.
Specs:
Size: 113mm
Weight frame only: 3.5grams
Weight RTF with AlienWii, 8mm dark edition motors and FC Guard: 33.5g
Included:
Top Frame Plate
Bottom Frame Plate
2 - M3x15 nylon standoffs
4 - M3x6 nylon screws
Adhesive velcro
Adhesive foam 3M tape
Fish line
Required for build:
7-8mm micro motor set
Flight control board
Battery (200-500mah)
Prop set
Radio system
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"