PhantoMounts Belt Drive Sony Action Cam Gimbal
for the DJI F450 Flame Wheel
(Assembled)
The PhantoMount Action Cam
gimbal features a 2:1 belt drive reduction and double ball bearings on
the roll axis for smoother travel and video quality. A direct servo
drive on the tilt axis reduces the forward weight, and simplifies the
overall operation of the gimbal. Purchase the carbon fiber F450/550
Flamewheel Legs and raise your F450 3.25" off the ground allowing 1.5"
of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI NAZA-M or Wookong-M flight controller
you can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
The PhantoMounts Action Cam
gimbal will arrive fully assembled and tested. Installation onto your
DJI F450 is easy too. Attach legs to your Flame Wheel and, mount the
gimbal to the bottom of your DJI F450 with the included hardware.
Connect to your flight controller, set up and tune the gimbal in the DJI
Assistant Software then film where you fly!
We recommend that you power
your PhantoMount Action Cam gimbal servos through a 6v BEC harness.
This will provide smoother reaction and cleaner videos.
The PhantoMount Action Cam
gimbal is intended for aerial photography with the camera out of its
case. For FPV flight, removal of the ports cover is required to access
the HDMI output.
This gimbal is also top plate convertible to fit multiple airframes with the PhantoMounts Top Plate Conversion Kits.
**SONY ACTION CAM AND DJI F450 NOT INCLUDED**
Required:
- Legs to raise your Flame Wheel
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
