PhantoMount X2 Phantom 2 Axis Gimbal
(Unassembled)
The PhantoMount X2 Phantom
gimbal frame and mounting plate is made of 1.5mm carbon fiber. Designed
to work on many platforms this gimbal utilizes two HiTec 5245MG Digital
Ball Bearing servos (sold separately) directly mounted to both the pitch
and roll axis of the camera. This reduces overall weight, moving parts
and greatly simplifies the design of the gimbal. Purchase the carbon
fiber PhantomFeet and Phantom Skids to raise your Phantom 1" off the
ground allowing clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza-m flight controller you can
directly power and control the gimbal. No additional expensive
stabilization controller is needed.
Installation onto your Phantom is easy too.
Simply attach the gimbal with two screws included with the hardware and
connect to your flight controller. Set up and tune the gimbal in the DJI
Assistant Software and film where you fly!
We recommend that you power your PhantoMount
X2 gimbal servos through a 6v BEC harness. This will provide smoother
reaction and cleaner videos.
The X2 version of the PhantoMount gimbals is
intended for aerial photography with the GoPro camera out of its case.
For FPV flight or if you want to have your camera in its protective case
then the PhantoMounts X2 Wide gimbal is more for you.
**HERO 3 GO PRO CAMERA AND DJI PHANTOM NOT INCLUDED**
Recommended:
Required:
Video out cable
for your GoPro camera. This video cable is needed for FPV flight, the
stock GoPro USB video out plug is too long for this mount:
Convert your PhantoMounts Gimbal to fit other airframes here:
Click here to order your PhantoMount X2
Spare Parts:
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
