PhantoMount X2 Wide F550 2 Axis Gimbal
(Assembled)



The PhantoMount X2 Wide
F550 gimbal frame and mounting plate is made of 1.5mm carbon fiber.
Designed to work on many platforms this gimbal utilizes two HiTec 5245MG
Digital Ball Bearing servos directly mounted to both the pitch and roll
axis of the camera. This reduces overall weight, moving parts and
greatly simplifies the design of the gimbal. Purchase the carbon fiber
F450/550 Flamewheel Legs to raise your F550 3.25" off the ground
allowing 1.5" of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
The X2 F550 gimbal will arrive fully
assembled and tested. Installation onto your DJI F550 is easy too.
Attach legs to your Flame Wheel and, mount the gimbal to the bottom of
your DJI F550 with the included hardware and connect to your flight
controller. Set up and tune the gimbal in the DJI Assistant Software and
film where you fly!
We recommend that you
power your PhantoMount X2 gimbal servos through a 6v BEC harness. This
will provide smoother reaction and cleaner videos.
The X2 Wide version of
the PhantoMount gimbals is intended for flight with your GoPro out of
case for FPV, in its protective case (no FPV) or, out of case no FPV.
**HERO 3 GO PRO CAMERA AND DJI F550 NOT INCLUDED**
Recommended:
- BEC Harness to power your servos
Required:



Video out cable for your GoPro
camera. This video cable is needed for FPV flight, the stock GoPro USB
video out plug is too long for this mount:
Convert your PhantoMounts Gimbal to fit other airframes here:
Click here to order your PhantoMount X2
Spare Parts:

Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"