PhantoMount X2 F550 2 Axis Gimbal
(Assembled)





The PhantoMount X2 F550
gimbal frame and mounting plate is made of 1.5mm carbon fiber. Designed
to work on many platforms this gimbal utilizes two HiTec 5245MG Digital
Ball Bearing servos directly mounted to both the pitch and roll axis of
the camera. This reduces overall weight, moving parts and greatly
simplifies the design of the gimbal. Purchase the carbon fiber F450/550
Flamewheel Legs and raise your F550 3.25" off the ground allowing 1.5"
of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
The X2 F550 gimbal will
arrive fully assembled and tested. Installation onto your DJI F550 is
easy too. Attach legs to your Flame Wheel and, mount the gimbal to the
bottom of your DJI F550 with the included hardware and connect to your
flight controller. Set up and tune the gimbal in the DJI Assistant
Software and film where you fly!
We recommend that you
power your PhantoMount X2 gimbal servos through a 6v BEC harness. This
will provide smoother reaction and cleaner videos.
The X2 version of the
PhantoMount gimbals is intended for aerial photography with the GoPro
camera out of its case. For FPV flight or if you want to have your
camera in its protective case then the PhantoMounts X2 Wide gimbal is
more for you.
**HERO 3 GO PRO CAMERA AND DJI F550 NOT INCLUDED**
Included:
- Assembled PhantoMount X2 F550 2 Axis gimbal
Required:



Video out cable for your GoPro
camera. This video cable is needed for FPV flight, the stock GoPro USB
video out plug is too long for this mount:
Convert your PhantoMounts Gimbal to fit other airframes here:
Click here to order your PhantoMount X2
Spare Parts:

Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"