PhantoMount X2 F450 2 Axis Wide Gimbal
(Unassembled)
The PhantoMount X2 F450
gimbal frame and mounting plate is made of 1.5mm carbon fiber. Designed
to work on many platforms this gimbal utilizes two HiTec 5245MG Digital
Ball Bearing servos (sold separately) directly mounted to both the pitch
and roll axis of the camera. This reduces overall weight, moving parts
and greatly simplifies the design of the gimbal. Purchase the carbon
fiber F450/550 Flamewheel Legs to raise your F450 3.25" off the ground
allowing 1.5" of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
Installation onto your DJI F450 is easy too.
Attach legs to your Flame Wheel and, mount the gimbal to the bottom of
your DJI F450 with the included hardware and connect to your flight
controller. Set up and tune the gimbal in the DJI Assistant Software and
film where you fly!
We recommend that you power your PhantoMount
X2 gimbal servos through a 6v BEC harness. This will provide smoother
reaction and cleaner videos.
The X2 Wide version of the PhantoMount
gimbals is intended for flight with your GoPro out of case for FPV, in
its protective case (no FPV) or, out of case no FPV.
**HERO 3 GO PRO CAMERA AND DJI F450 NOT INCLUDED**
Required:
Video out cable for your GoPro
camera. This video cable is needed for FPV flight, the stock GoPro USB
video out plug is too long for this mount:
Convert your PhantoMounts Gimbal to fit other airframes here:
Click here to order your PhantoMount X2
Spare Parts:
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
