Description:


Nano sized brushed flight controller ideal for DIY multicopters with up to 6 brushed motors. Comes pre-installed with latest CleanFlight firmware, with tweaks and defaults made to utilise everything from this tiny flight controller!

Features:

Baseflight & Cleanflight compatible
Single side populated (for super easy mounting with double side tape)
2.9g
MPU6050 Accelerometer + Gyroscope
Baro pads (chip not populated currently)
Mag pads (chip not populated currently)
Brushed motor support up to 6 motors (all populated with Nfets)
6.3A N Channel fets
Flight battery voltage monitoring
Spektrum Satellite (3.3v) or PPM (vbatt) rx input
Spektrum bind button (hold on boot to bind)
RSSI PWM to Analog (RC circuit) on ADC5
CH2, ADC5 pads available as solder pads
3.3v Buck/Boost regulator (no brownouts) for super clean power
1S (4.2V) only (maximum input voltage 5.5v)
Expansion headers (SPI, SWDIO/SWCLK, Serial0, Serial1, CH7, CH8, 3.3V, VBAT, GND)
WS2812B LED header (including logic level converter to power LEDs direct from VBATT)
Buzzer led for low battery alarm (bright LED could also be used)
Buzzer transistor either for physical buzzer or a simple LED
Connectors all around edge and on both sides with labels
I2C pads broken out
3.3v and GND pads for auxiliary expansion

Documentation:

The product user manual can be found here: Manual