Note: It is highly recommend user to enable FailSafe. Some copters'
controller does not have fail-safe system implemented. At the case where
the quad copter has flown very far away from the transmitter (eg. 2 km
away from transmitter for Aerial photography application), RF signal may
have faded due to far distance. FailSafe allows the receiver to output
default signal when signal is lost to keep the quad copter flying until
signal is recovered again.
2) Provide power to the unit.
3) Enable bind mode in transmitter and ensure distance separation of 2 meters from receiver.
Failsafe Enable
1) Plug bind plug to the receiver.
2) Provide power to the unit.
3) Press the FailSafe button for memorize current position in Failsafe mode.
4) Green light will turn on at the bottom of the receiver to indicate Failsafe is successfully enabled.
5) Remove bind plug.
Failsafe Disable
1) Rebind the receiver without pressing the side FailSafe button will disable the Failsafe mode.
2) Green light off indicates Failsafe disabled.
Type:
|
DSMX PPM 8-Channel Receiver
|
Number of Channel:
|
8 (PPM signal)
|
Modulation:
|
DSMX (DSM2 backward compatiable)
|
Band:
|
2.4 GHz
|
Dimension:
|
25(L) x 35(W) x 7(H) mm
|
Weight:
|
4.8 gram without casing
|
Voltage Range:
|
3.45 - 7.2V
|
Highlight:
- FailSafe option via press of a button to guranteed the highest level of safety even in the event of RF signal loss
- 3 microprocessors based system to ensure the highest performance available
- Designed especially for Copter high current drain application.
Setup Instruction:
- Website is being updated. Please see text printed on PCB for brief
descriptions. Full setup instruction will be released by May 16, 2014.