Gaui Retractable Folding Landing Gear
**Connects to a switch on your TX to activate fold/unfolding the landing gear.**
**If you have a DJI Flamewheel F450-F550 you will ALSO NEED to add the Retractable Landing gear MOUNTING PLATE.
Please click the arrow link below!**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
**Mounting Plate, Frame, Electronics and Props NOT INCLUDED**
Install retracting
landing gear onto your Flame Wheel and get 11 inches off the ground and
allows for a 360 degree pan without the landing gear in view. The GAUI
retracts plug into an open channel on your receiver and operate on a 2
position switch. The PFG mounting plate is cut from 3.0mm solid carbon
fiber and mounts in minuets using four arm screws. All necessary
hardware is included for mounting these retracts to your F450 / F550 and
more. Take full advantage of your gimbals panning capability!
*Please note: This kit
was designed for the GAUI 540H and DJI F450 and F550 but can be used on just about any
frame. Maximum recommended craft weight 10lbs. due to the GAUI Landing
Gear.
Specs:
Overall Dimensions: 290x75mm
Center Slot Mounting: 20x20mm - 50x50mm
Weight:
F450: 289 grams
F550 293 grams
If you have a DJI
Flamewheel F450-F550 you will ALSO NEED to add the Retractable Landing
gear MOUNTING PLATE. Please click the arrow link below!
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
Before you purchase these Gaui retracts please check out our new carbon fiber retracts.
