DJI S800 Retractable Landing Gear w/2 High Voltage Servos






Overview
The retractable landing gear, another
innovative design from DJI, is designed for the S800 Hex-copter in order
to provide a better perspective in areal filming / photography work. By
using a 2-position switch channel of the R/C transmitter, you can
control the landing gear to retract remotely. The retractable landing
gear will not block the view of the camera lens, making smooth shooting
in all directions possible.
The retractable landing gear will not block
the view of the camera lens, making smooth shooting in all directions
possible. Gone are the days of seeing any part of your S800 in a shot.
The creative design of the over center locking
mechanism ensures the landing gear maintains a fixed/locked position
even when there is a power failure. The innovative design makes the
structure stable and reliable.
Install the servo arm according to the
instructions and then calibrate in accordance with the LED indicator,
the adaptive function of travel calibration makes it easy to calibrate.
After calibration, both left and right legs are in the lowered position,
and the LED is on solid green. Then the landing gear is ready for use.
The system is delivered ready calibrated.
The S800 retractable landing gear has a
built-in BEC module, which is compatible with a 3S-6S Lipo battery. It
can be powered independently or from the S800 center frame.
The retractable landing gear only consumes
power when retracting or lowering, under other conditions the system is
automatically in standby mode, which greatly reduces the system power
consumption and improves the system efficiency.
If the switch channel on the TX has fail-safe
function, set the fail-safe value to the lower position, so that the
landing gear will be lowered when the receiver enters failsafe, to land
the aircraft safely.
When powering on the system, if the TX switch
is in the retract position, which is the unsafe signal for the landing
gear, the LED will quickly flash RED. The landing gear will not retract
until you toggle the TX retract switch.
If the S800 retractable landing gear is
obstructed for a long time during retracting or lowering, then the
system will start the servo block protection function to protect the
servo from damage.
In order to avoid complex operation, the S800
retractable landing gear is designed to give simplified setup and
operation. You can just use any 2-position switch channel to control the
landing gear.
Basic Parameters |
Working Voltage |
3S~6S (LiPo) |
Working Current |
Max 1A@6S |
Working Temperature |
-20~70°C |
Total Weight |
875g |
Working Parameters |
Input Signal |
PWM (High-Pulse Width 800us~2200us) |
Output Signal |
PWM(Neutral Position is 1520us) in 90Hz |
Output Voltage |
6V |
Servo Travel |
150° (Minimum 120°) |