**In Stock Now Shipping**
AbuseMark Amaze Rev.3 AfroMini 32
Mini Naze32 Flight Controller/FC
**OPTIONAL 90 Degree Pin connector**
Requires USB>3.3V serial cable (not included)Currently shipping rev3 BLACK 0.8mm thin boards.
- 33mm x 16.5mm
- 1.75 gram without headers
- STM32F103CBT6 32-bit Cortex M3 processor
- MPU6050 Accelerometer/Gyro
- BMP085 Barometer (rev0)
- BMP180 Barometer (rev1)
- BMP280 Barometer (rev3)
- Only supports PPM RC Input
- 1 throttle, 4 servo outputs (for airplane mode)
- 4 motor outputs for quadrotor mode (rev0)
- 6 motor outputs for multirotor mode (rev1, rev3)
- 2 3.3V analog inputs (for pitot etc in airplane mode, rev0)
- Battery voltage monitor (rev3)
- Futaba s.bus inverter built in (rev3)
- Buzzer output (rev3)
- Additional UART pads for GPS/Spektrum
- Currently shipping version can be powered with up to 16V
Note: Hardware cannot be used with any DJI frames. This includes: FlameWheel 330, 450, 550, or any future or past frames released by DJI.
Note: Using hardware with anything other than supplied "baseflight" firmware will immediately make the end user ineligible for any kind of support or warranty.